CFD studies are brought to use for understanding the de-stratification phenomenon and flow profile because of employing HVLS Fans. This case study specifically focusses on the MRF capability in Ansys fluent to simulate such large geometries in rotation.
CDA FEA CFD
By cpdlrglobal CDA FEA CFD
The primary objective of this case study is to analyze the effect of using nanoparticles in water (base-fluid) on heat transfer. To model nanoparticles in water in ANSYS Fluent, both the single phase as well as multiphase approach was used in this study and a comparison was made at the end.
By cpdlrglobal CDA FEA CFD
Several research papers with different types of roughness in solar air heater have been examined by researchers in the past. This academic study highlights a sample casework involving rectangular ribs and the effect on Nusselt number (highlighting higher heat transfer) in comparative with smooth duct.
By cpdlrglobal CDA FEA CFD
This case study simulates a typical linear spring connection and explains the technical spectrum of using spring connections in FEA studies. Non Linear spring segment is not a part of this study .
By cpdlrglobal CDA FEA CFD
This study provides for a technique of simulating performance of pleated filters used in filtration system utilizing the porous media simulation capability of ANSYS Fluent .
By cpdlrglobal CDA FEA CFD
This CFD study showcase the effects on solidification on Phase change material in an energy storage tube with and without fins.
By cpdlrglobal CDA FEA CFD
In this work based on FEA studies, the contact stress and deformation are analyzed and calculated, which provide the basis for the design and optimization of deep groove ball bearings.
By cpdlrglobal CDA FEA CFD
Computational Fluid Dynamics plays an important role in areas of visualizing flow dynamics . In this case study application of CFD in design features of a shuttle cock is presented.
By cpdlrglobal CDA FEA CFD
In the presented case study sloshing phenomenon in oil tanker was simulated using Vof (Volume Of Fluid) multiphase model in ANSYS Fluent.
By cpdlrglobal CDA FEA CFD
In this case study, ANSYS Workbench FEA has been used to investigate the response of the existing SAE frame (e.g., stresses and deflections) under various types of impact. The Static Structural Module has been used against the Front, Side, roll over and Torsional impact.